»

In BRec, I am getting an error which says “Access to .\log\BRec …was denied”. What is the problem?

BRec,Uncategorized — Administrator @ 5:48 pm

BRec writes an operations log every time it runs.  In order to write the log, the BRec image must have read/write access to the folder BRec is run from.  Usually, running BRec in administrator mode will clear the error message.   If using a shortcut, this option is found in the properties of the shortcut.

0 Comments

No comments yet.

RSS feed for comments on this post.

Sorry, the comment form is closed at this time.

This work is licensed under a Creative Commons Attribution-Noncommercial-Share Alike 3.0 Unported License.
(c) 2022 Skymicro FAQ | powered by WordPress with Barecity